[ZaGhost]

Replaced the rear brake pad.... What fun, seized caliper pins.... lots of PB Blaster, heat and thumping...
Sore and tired, but done
Also replaced my broken mirror with a set of cheapies and replaced the bar ends( rubbers were toast)
Mirrors vibrate a bit more than I'd like... may look around for a stock one yet.,....

 

[HyperMongoose]

Jammed my fingers in the sprocket trying to mount the rear wheel *grumblz*

Friggin' spacer won't stay in place... *more grumblz*

 

[ish474]

Fixed my fuel leak and RODE IT. Only two years after I took it apart to pain it! Rain or no rain had too

 

[farmer_frank]

Aftermarket or H-D branded? I was actually thinking about those as a possible future upgrade - very interested to hear about output/pattern vs stock.

Write up has been posted. http://www.svrider.com/forum/showthread.php?t=310785

 

[r0ckrat]

Cleaned, lubed, and adjusted the chain after getting home form work.

 

[taziscool]

Put my new to me sv gel seat on, any one interested in a like new front seat with only 5k miles on it?

 

[Born again Biker]

Fixed my fuel leak and RODE IT. Only two years after I took it apart to pain it! Rain or no rain had too

So how much "pain" did you give it? :evil6:

 

[onecartel]

Write up has been posted. http://www.svrider.com/forum/showthread.php?t=310785

Thanks for posting this, I'm going to explore this Daymaker for a friend's Triumph.

 

[2003_Sv650s]

To give you some teaser photos of the "Build to come" or "Winter project 2k15"

Purchased a used S headlight this morning. So that will get here soon I'm sure.

Yesterday I received these!!!
(G37 Sedan 3" HID Projectors)

 

[chdrummerdude]

Ordered a delkevic 200mm slip on and motosliders no cuts today! Pix to follow!

 

[SVTwins]

I am repainting the rash on the tail section of my sv1000s. If youre interested, my build/comment thread is HERE

 

[t1r2u3s4t]

Those G37 projectors will fit inside the S housing?

To give you some teaser photos of the "Build to come" or "Winter project 2k15"

Purchased a used S headlight this morning. So that will get here soon I'm sure.

Yesterday I received these!!!
(G37 Sedan 3" HID Projectors)

 

[robtech]

installed some cheap barend mirrors ive had layin around to see how i like em before i invest in some nice ones...so far i dig em

 

[2003_Sv650s]

Those G37 projectors will fit inside the S housing?

Well I guess we will find out soon enough. I'll post a build thread. I'm sure I can make it fit.

 

[onecartel]

Installed new exhaust springs.

 

[OfirMX]

Installed new exhaust springs.

Did you use progressive or constant-rate springs?

I think my exhaust springs are too soft for my weight.

 

[farmer_frank]

Did you use progressive or constant-rate springs?

I think my exhaust springs are too soft for my weight.

Maybe you're two heavy for your springs and need a lighter rider?

 

[chdrummerdude]

Washed and waxed the bike, then watched mail lady deliver my motoslider frame sliders. Promptly installed them and re waxed the bike lol!

 

[OfirMX]

Maybe you're two heavy for your springs and need a lighter rider?

Will a lighter rider also reduce the popping thing?

 

[onecartel]

Did you use progressive or constant-rate springs?

I think my exhaust springs are too soft for my weight.

Single rate. Progressive is dangerous for wheelies but I hear it helps for bunny hops.

Today I washed my car and SV. I haven't driven the car in a few years. There was a dead/partially decomped bird under it. I'm sure that's a sign of good luck.