Suzuki SV650 Riders Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
Got my new all balls wheel bearings in and I went to put the new seal on the sprocket bearing. Currently the id of the seal is about 2-3mm away from the inner race of the bearing. That's not normal right? Can't seem to get the seal to go any lower (and I'm dreading cleaning the old bearing to use as a driver...).
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top