Suzuki SV650 Riders Forum banner

SVRacing Parts Rear Sets: Rubber Shifter

916 views 8 replies 6 participants last post by  leed 
#1 ·
#2 ·
First thought I had was to smooth down the knurls on the underside of the shift peg. I've had similar wear on my boots and will be sanding the bottom of mine. The knurls are a bit too sharp and a good sanding might alleviate or eliminate your problem.
Good luck


Sent from my iPhone using Motorcycle
 
#5 ·
No prob! But I still recommend sanding it a bit on underside. Your choice tho.


Sent from my iPhone using Motorcycle
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top