Suzuki SV650 Riders Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter · #1 ·
I've searched you tube and some of our forums. I am replacing the throttle cables on my 2004 SV 650 S to complete my handlebar rising / upright seating project. How do I install the cables on the motor side? I had no problems on the handlebar end. Please direct me to the resource that clearly tells/shows me how the cable ends are connected. I would think that the instructions would be plentiful, like on the handlebar end. I have the Haynes Online Manual. Is the Chilton manual any better on this topic? I have attached a photo of the bike's right side for an overview, showing the handlebar end loosely attached and the old cables leading to the area of problems. I also attached 2 close up photos , one shows the cables detached from the holders, the other just showing confusion. I hoping that one of you all sees this post and knows my solution. Someone posted a service manual of 650 pages on our site but I can't locate it.
Motor vehicle Product Automotive design Building Engineering
Motor vehicle Gas Automotive exhaust Automotive fuel system Auto part
Auto part Motor vehicle Metal Automotive fuel system Close-up
 

·
Registered
Joined
·
49 Posts
Discussion Starter · #5 ·
Thanks you guys! I removed the throttle bodies which wasn't too difficult, once I found the correct screws were clamps. Once loosened they popped off with some wiggling back and forth. I'll post some photos when I finish the job, hopefully this am! Someone posted the electronic shop manual and I can't find it. If anyone has it please send! It will be helpful for future projects. Dave D's photos of just a few pages are clearly superior to the online Haynes Manual I bought.
 
1 - 4 of 4 Posts
Top