[dawei213]

How do I remove the old connector plugs from my old turn signals to a pair of new turn signals I just got? I tried tugging it but it won't move.

Any advice would be greatly appreciate it.

 

[Mudsurfer1234]

If you are talking about the grey cylinder-shaped connectors, there is a little clasp that you need to pry up to take them apart. It's a little locking clip to keep them together.

 

[dawei213]

Ok thanks, I'll give that a try later tonight.

 

[gritmeister]

Are you trying to separate the lights from the bike, or the cylinders from the wire? I have been trying to figure out how to re-use the cylinders so I can connect my new lights to the wiring harness without cutting and splicing.

 

[gritmeister]

Found this thread.

 

[Nudist]

Cut - solder back together, heat shrink tube, install

 

[Panth]

Cut - solder back together, heat shrink tube, install

Worked for me.