Suzuki SV650 Riders Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I was just wondering if the case sized changed from a Gen 1 motor to a Gen 2 motor? I am looking to swap out the motor from my 2002 (Gen 1) that has a spun bearing with a 2007 (Gen 2) motor. I am aware that somethings have to be swapped over. I was wondering if it would bolt up the same.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top