Suzuki SV650 Riders Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I try to find the cam timing of SV650 1st and 2nd Gen. But I only found this two sites:

http://www.suzukicycles.org/SV-series/SV650_specs.shtml
1st Gen:
Intake valve timing:
Open BTDC 28 degrees
Close ABDC 62 degrees
Duration 270 degrees
Exhaust valve timing:
Open BBDC 43 degrees
Close ATDC 24 degrees
Duration 247 degrees

http://www.aperaceparts.com/tech/specssv650.html
Intake Valve Timing:
Open BTDC 33 degrees
Close ABDC 66 degrees
Duration 279 degrees
Exhaust Valve Timing:
Open BBDC 55 degrees
Close ATDC 66 degrees (imposible, 28?!)
Duration 263 degrees

Are this timings right ???

PS: Maybe someone also know the timing of the DL650 V-Strom?
 

·
Registered
Joined
·
1,323 Posts
Bringing this old thread back from the dead. I'm also wondering about the DL650 Cam specs and if the Gladius (SVF) motors have the same cam specs as the Gen2's
 

·
Registered
Joined
·
9,569 Posts
DL650 cams are slightly different from the SVs, and SFV cams are also different.

And not every cam gear is pressed on at the factory is at the exact same spot. So you could have an intake cam from the same model at 108 center, and then another one at 107.
 
1 - 3 of 3 Posts
Top