[SafireEyz]

I don't think these sliders are in the right spot but I am not sure... anyone have a pic of theirs?

 

[99Sv650N]

Not 100% BUT I dont think so...

 

[99Sv650N]

I beleive they go on the bolt thats on the frame bolt that just the the lower right of the sliders.

 

[silversx80]

Some of the Gen 1 sliders go there. The Motosliders, and I think T-Rex sliders go through the bolt below the sliders picrtured.

 

[jbswear]

What brand slider is that? I have seen them there. And cringed.

If that's your bike, order Nate's Motosliders, remove those pieces o' crap and put his in the correct place: the bolt that is just below and in front of where those are.

 

[promazda]

What brand slider is that? I have seen them there. And cringed.

If that's your bike, order Nate's Motosliders, remove those pieces o' crap and put his in the correct place: the bolt that is just below and in front of where those are.

I agree I had those sliders and went down first thing hit the ground was handle bar then gas tank. the only thing they will protect is the frame. Went down on motosliders and they were first to hit the ground besides my pegs.

 

[SafireEyz]

That is what I thought.... where do I get Nate's??

 

[jbswear]

If you keep refreshing the page, eventually it'll show up in the banner ad up top.

 

[jbswear]

http://www.motosliders.com/

 

[Dstritt]

Are Swingarm sliders necessary?

I was looking to get some of nates frame sliders and saw there are swing are sliders as well...

 

[jbswear]

Not necessary, but the day AFTER I installed a set I bought from DougZ (on this board; $30, or so) my bike was dropped from a stop by a new rider.

Both Nate's left side slider and Doug's left side slider were marred by the asphalt, but the only damage to the bike was a slightly bent clutch lever.

Worth it? I think so.

 

[BlackHawk]

They are nice because they have the spools on them as well easier to use a rear stand IMO.

 

[jbswear]

They are nice because they have the spools on them as well easier to use a rear stand IMO.

+1


That, and they look a helluva lot better than the simple 12mm hex bolts I was using as stand spools...

 

[Dstritt]

Thanks for the advice guys!