[kingnothing]

I was wondering if anyone has these risers on their bike. If so, how do you like them? Did you have to get different control lines?

http://www.1tail.com/sa/cart/detail.asp?pg={F75BA66B-C5E0-4250-9156-35B30621E3E2}

*EDIT*

because I'm an intertubz moron, i don't know why that "link" above is not clickable. Just copy and paste.

 

[BamBam]

http://www.1tail.com/sa/cart/detail.asp?pg={F75BA66B-C5E0-4250-9156-35B30621E3E2}

little help

 

[Trambo]

Are those the Gen Mar risers? There are plenty of folks with those, I've heard a lot of good things about them.

 

[Ranger]

Might have to move the clutch line but the rise doesn't look big enough for a difference in lines, especially for the N model.

 

[Trambo]

Most of what I've read on the Gen Mars (for the 1" up, 1.5" back model)say that the stock clutch & throttle cables will work in N models, though you may have to slightly reroute them.

 

[herbn]

i can't believe that no one makes clamps for straight off the crown that go higher,all those set ups just look awful to me,just my .02. also wouldn't they block up the ignition access a bit?

 

[Trambo]

i can't believe that no one makes clamps for straight off the crown that go higher,all those set ups just look awful to me,just my .02. also wouldn't they block up the ignition access a bit?

More than one way to skin a cat. Some people acheive the same results (improved body positioning) with different bars, such as BikeMaster Daytonas. But that requires drilling, remounting controls, etc... so for non-mechanically inclined folks, the risers are simpler.

 

[Veabers]

I have those risers on my 08 Naked and I love them.

I didn't have to change any lines, but I did have to snip one tie wrap to make a little more slack.

The only issue I have found is that I have to remove them to lift the tank up, but not that big of a deal unless you plan on being under your tank on a regular basis.

 

[SV Racing Parts]

I was wondering if anyone has these risers on their bike. If so, how do you like them? Did you have to get different control lines?

http://www.1tail.com/sa/cart/detail.asp?pg={F75BA66B-C5E0-4250-9156-35B30621E3E2}

*EDIT*

because I'm an intertubz moron, i don't know why that "link" above is not clickable. Just copy and paste.

Those are the one up and one back from Gen Mar, they work on the N models only with no need to extend your brake lines,

I provide them to the members at $98.95 and $10 Flat Rate Shipping, by USPS Priority, to your door, anywhere in the USA,

Your Choice of brushed Aluminum or Anodized Black Finish.

Let me know whenever you are ready, Email me at [email protected] and I will look after you right away,

Enjoy the ride, and best regards,
Blair