Suzuki SV650 Riders Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
537 Posts
Where did you get your riser plates at?
those are "nate's plates"  ;)  IIRC, it adds 1.5" back and up.  the woodcrafts there are the more aggressive angled and also add 1.5" so essentially i had 3" up n' back rearsets from stock.

i don't run that setup anymore, mostly cause i munged up 1 of the relocator plates in a lowside on the track. good thing is the relocator plate bent a little but the rearset was intact (minus the peg that took most of the force and ground down to 1")
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top