Suzuki SV650 Riders Forum banner

1 - 20 of 33 Posts

·
Registered
Joined
·
1,520 Posts
Discussion Starter #1
Received them this afternoon. They're suh-weet! They're made out of 1/16" 5052 aluminum and are cut via waterjet. Unfortunately, most of these are already sold (check my other thread for more information). If the demand is high enough, I'll make a second batch.

Here's some eye candy:



#1


#2


#3


#4


#5


#2 mounted






#5 assembled with factory license plate light




As you can see, they'll fit quite nice in a flat-rate envelope. This means they're only $5 to ship (unbent) to anywhere in the U.S.!


I will PM everybody who's reserved a bracket with payment info.

Thanks SV'ers!
 

·
Registered
Joined
·
24 Posts
Payment Status: Complete.

Can't wait for the #5

Thanks again Dub
 

·
Registered
Joined
·
421 Posts
great job on these. payment sent. thanks!
 

·
Registered
Joined
·
1,520 Posts
Discussion Starter #14
All fender eliminators that have been paid for have been shipped via USPS Priority. They should arrive in a few days!
 

·
Registered
Joined
·
667 Posts
Where should the bend be? right at the point where the plate holder comes out? Also what angle did you bend it? I think the metal shop at school has a break that I'll try to get them to let me use.
 

·
Registered
Joined
·
421 Posts
what are you guys planning to use to bend them with to make them look proper?
 

·
Registered
Joined
·
1,520 Posts
Discussion Starter #18
The main bend should be right where the plate holder juts out from the subframe bracket. I'd bend it down not quite perpendicular (90 degrees).
 
1 - 20 of 33 Posts
Top