Suzuki SV650 Riders Forum banner
1 - 20 of 73 Posts

· Registered
Joined
·
293 Posts
Discussion Starter · #1 ·
The bike:



Parts so far:
2003 Hayabusa Wheel w/ 320mm rotors
2007 GSXR 750 Forks
2007 GSXR 750 Radial Master Cylinder
2007 GSXR 750 Calipers
2007 GSXR 750 Lower Triple and Stem
2007 GSXR 750 Steering Damper
LSL Offset Match Clip Ons (Black Bars)
Right side axle spacer made by Zoran







Parts on the way:
2006 GSXR 1000 Top Triple
2007 GSXR Pazzo Shorty Brake Lever (Black/Black)
GSXR Speedo Sender
GSXR Front Fender
DZC 5mm Caliper Spacers
DZC GSXR Steering Damper Bracket

Parts left:
Galfer Lines

Wish me luck! ;)
 

· Premium Member
Joined
·
17,865 Posts
it's easy you'll be fine. Just keep track of bolt 636-412793640859385603850485901023059-a
 

· Registered
Joined
·
293 Posts
Discussion Starter · #9 ·
A couple of things are required to integrate the Hayabusa wheel:
1) 320mm rotor requires 5mm caliper spacers
2) Rotor spacing on center is 134mm vs GSXR 132mm
- requires 1mm machined off inside face of each rotor to bring back to 132mm centers
3) Wheel center/spacing;
- Hayabusa is 214mm fork spacing (on center); GSXR is 207mm.
- requires (214-207)/2 off the right GSXR axle spacer. (12.25 - 3.5 = 8.75mm net)
:)
 

· Registered
Joined
·
105 Posts
Gonna look nice. It'll ride even better. It was a night and day difference when I modded my SVS. Just remember you'll have to lower your front fairing a tad so you can get clearance for those nice LSL clip ons.
 
1 - 20 of 73 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top