Suzuki SV650 Riders Forum banner

1 - 4 of 4 Posts
K

·
Guest
Joined
·
0 Posts
Discussion Starter #1
I will be ordering my sonic springs tomorow and installing preload adjusters.
i baught them from a member of this board.
Will i have to change any washers or spacers to install the preload adjusters on my 01 sv.
 

·
Registered
Joined
·
737 Posts
You'll need a flat washer - basically a disc without any hole in the middle. That's what your preload cap will push against.
 
K

·
Guest
Joined
·
0 Posts
Discussion Starter #3
I will need to cut my stock spacers or make new ones when installing the preload adjusters. Right??
 

·
Registered
Joined
·
480 Posts
Kid Thunder said:
I will need to cut my stock spacers or make new ones when installing the preload adjusters. Right??
if your sag is about right with the spacers that are in there now, just subtract the extra length of the preload adjuster caps from the spacers.
 
1 - 4 of 4 Posts
Top