Suzuki SV650 Forum: SV650, SV1000, Gladius Forums - View Single Post - Clean and Simple CBR600 Build
View Single Post
Old 06-16-2010, 08:21 AM   #9
Knifemaker87
Senior Member
 
Knifemaker87's Avatar
 
Join Date: Aug 2007
Location: Newport News
Bikes: White 'n Blue 2006 SV650S
Miles Kms: 7.5 k
Posts: 1,477
Send a message via AIM to Knifemaker87
Re: Clean and Simple CBR600 Build

well, didnt have much time to work, but i did get the side covers at least put together.

All the fitting was done, so all i had to do was tack weld them, pull them off and finish welding the seam, then cover up my bad welding by grinding everything flat:


here is a rough fit.. after grinding... still needs alot of fine tuning:


profile:


put some primer on there to keep it from rusting till i can fine tune them up:


wanna see some ugly welding? bondo coming soon!


i am still trying to figure out how i am going to secure both the side-panels and the tail... ideas would be helpful.
thanks!
~Chris
Knifemaker87 is offline   Reply With Quote