Suzuki SV650 Forum: SV650, SV1000, Gladius Forums - View Single Post - Clean and Simple CBR600 Build
View Single Post
Old 06-11-2010, 09:46 AM   #9
Knifemaker87
Senior Member
 
Knifemaker87's Avatar
 
Join Date: Aug 2007
Location: Newport News
Bikes: White 'n Blue 2006 SV650S
Miles Kms: 7.5 k
Posts: 1,477
Send a message via AIM to Knifemaker87
Re: Clean and Simple CBR600 Build

Quote:
Originally Posted by JPL_SV View Post
Nice custom metal work. Project is looking interesting.
thanks! we will see where it goes.

Quote:
Originally Posted by SkyWest View Post
You probably know this and I can't see very clearly, but when joining the sheet metal use a series of tacks and skip around a lot. Too much time in one place will let the heat build up and warp that assembly. In other words don't try to run a traditional bead.

Interesting project, thanks for sharing.
thanks for the advice. Yeah... i normally tack weld it and the alternate filling in between the tack welds switching back and forth so as to lessen the warping.
thanks!
~Chris
Knifemaker87 is offline   Reply With Quote