Originally Posted by tovar
How did you route cable?
Is your mechanism smooth, no balls missing in there?
The piece pushing against pressure plate with bearing has washer between bearing and plate, is washer there?
Cable goes straight after entering the hole in the frame, left side of the metal throttle cable bracket, under the throttle bodies, arc left.
I swapped to a new clutch adjustment mechanism its like butter.
Washer is between pressure plate and bearing.
Measured all the rods are matching length, less torque on the basket, flipped the washer between the hub. Doesn't even clunk into 1st when warm with these parts.
Strange that the push rod hat can spin even though the bearing is ok.